A used fridge can be the best bargain in your kitchen or the most expensive mistake. From the outside, a tired unit and a sound one can look almost identical. The difference shows up a week later, when the compressor starts knocking or the cabinet will not drop below 8°C on a hot afternoon. Knowing how to inspect a used commercial fridge protects your money and your stock. This guide walks through the checks we run on every fridge before it goes on our showroom floor, the warning signs that mean walk away, and a printable checklist to take to any inspection.
Key takeaways
- Start with the data plate: model, electrical rating and refrigerant tell you what you are buying.
- Test every door seal with a strip of paper, and check hinges close the door firmly on their own.
- Listen to the compressor and look at the condenser: steady running is good, knocking or oily pipework is not.
- Run a temperature test with your own thermometer and confirm the cabinet reaches 5°C or below.
- Walk away from fridges that cannot hold temperature, show signs of refrigerant leaks or have no parts support.
- Buy from a dealer who has already done these checks, and get the warranty in writing.
How to Inspect a Used Commercial Fridge: Eight Checks
You do not need to be a refrigeration mechanic to spot most problems. You need a probe thermometer, a strip of paper, a torch and about 30 minutes. Learning how to inspect a used commercial fridge comes down to eight checks, grouped below into six areas. Work through them in order, because the early checks often tell you whether the later ones are worth doing.
Before you go, pack a small kit: a probe thermometer, a torch, a strip of paper for the seal test, your phone for photos of the data plate and any damage, and a tape measure so you can confirm the fridge will fit through your doorways and into its space. Ask the seller to have the fridge switched on and running for at least a few hours before you arrive. A fridge that has been sitting switched off in a shed tells you very little until it has been running for a while.
1. Paperwork: the data plate and refrigerant
Every commercial fridge has a data plate, usually inside the door frame or on the back. Photograph it. It tells you the brand, model, serial number, electrical rating and refrigerant type. The model number lets you check whether parts are still available, and the electrical rating tells you whether it runs on a standard 10 amp outlet or needs a dedicated circuit. The refrigerant matters too, because some older refrigerants are being phased down under the Australian Government’s ozone and synthetic greenhouse gas program, which can make future regassing more expensive. A missing or unreadable plate is a warning sign in itself.
2. Outside: cabinet, castors and power lead
Walk around the unit. Minor dents are cosmetic, but rust around the base, hinges or where the cabinet meets the floor suggests years of moisture. Check the castors or legs sit level and secure, because an uneven fridge can stop doors closing properly. Inspect the power lead and plug for cracks, heat damage or tape repairs. A damaged lead should be replaced by an electrician before the unit goes anywhere near your kitchen.
3. Doors: seals, hinges and glass
Door seals are the most common failure point on any commercial fridge. Close the door on a strip of paper at several points, including all four corners. You should feel firm resistance as you pull it out. Look closely for splits, flattened sections or mould. Then open each door halfway and let go. It should swing closed and seal on its own. On glass door fridges, look for fogging or moisture between the panes, which means the double glazing has failed. Seals are cheap to replace; glass is not.
4. Inside: liners, shelving, lights and smell
Open every door and look inside with a torch. Cracked liners can trap moisture and bacteria. Check the shelf supports are all present and the shelves sit level. Turn on the lights if fitted. Then trust your nose: a lingering sour or mouldy smell can point to a blocked drain or damaged insulation, both of which are hard to fix properly.
5. Machinery: condenser, compressor and fans
Find the condenser coil, usually behind a grille at the top or bottom. Dust on the coil is common and fixable with a clean, but oily residue on the pipework or around joints can indicate a refrigerant leak. With the fridge running, listen to the compressor. A steady hum is good. Loud knocking, rattling or a compressor that switches on and off every minute or two suggests a fault. Check the condenser and evaporator fans spin freely and quietly, because a failing fan reduces cooling long before it stops completely.
6. Performance: temperature, defrost and drainage
This is the check that matters most. Switch the fridge on empty, close the doors and place your own probe thermometer on the middle shelf. The temperature should fall steadily and reach 5°C or below, the cold-holding benchmark set by Food Standards Australia New Zealand. Then open and close the doors a few times, as staff would during service, and watch how quickly it recovers. While you wait, look for heavy ice on the evaporator, which can point to a defrost or seal fault, and check the drain is clear with no water pooling inside.
Forty Years of Hospitality Expertise, Since 1984
Since 1984 we have supplied the hospitality industry with professional advice, reliable equipment and excellent customer service. We have a wealth of experience in all types of projects ranging from international hotels to large and small pubs through to suburban restaurants and takeaway outlets. All our staff are equipped with the knowledge, expertise and creativity to add value to your project.
Refrigeration is in our name, and forty years of servicing fridges means we know exactly where each brand tends to wear first. That knowledge goes into every refurbished fridge we sell, and into the advice we give when customers bring us a used unit they are thinking of buying elsewhere. Read more about our history.
Browse the refurbished stock
Every refurbished fridge on our floor has been through the checks in this guide before it goes on sale. Visit the showroom at 15 Station Street to see units running, or browse online and ask the team about any model. No charge, no pressure, just straight answers.
See refurbished fridgesWarning Signs: Fix, Negotiate or Walk Away
Not every fault is a deal-breaker. Some are cheap fixes that should simply come off the price. Others mean the fridge is not worth taking home at any price. Use this table to sort what you find during your inspection.
| What you notice | Likely cause | Verdict |
|---|---|---|
| Dust-clogged condenser coil | Poor cleaning | Fixable: clean it and retest |
| Split or flattened door seal | Wear | Fixable: seals are replaceable, factor in the cost |
| Door does not close on its own | Hinge or closer wear | Fixable on most models |
| Fogging between glass panes | Failed double glazing | Negotiate: glass replacement is costly |
| Heavy ice build-up on the evaporator | Defrost, fan or seal fault | Negotiate: needs diagnosis |
| Compressor knocking or cycling on and off | Compressor or control fault | Walk away unless repaired and retested |
| Oily residue on pipework | Possible refrigerant leak | Walk away unless repaired and regassed |
| Cannot reach 5°C | Refrigeration fault | Walk away |
General guidance only. A refrigeration mechanic can confirm the cause of any fault.
The rule of thumb is simple. Anything to do with cleanliness, seals or hinges is usually fixable. Anything to do with the sealed refrigeration system, meaning the compressor, the refrigerant or the ability to hold temperature, needs a qualified refrigeration mechanic and can cost more than the fridge is worth. If you are not sure, ask for the unit to be repaired and retested before you buy, or choose one that has already been through that process.
It also pays to think about timing. A fridge inspected on a mild winter morning has an easy test. The same unit can struggle on a 38°C summer afternoon in a hot kitchen. If the fridge only just reaches 5°C in a cool showroom, assume it will have trouble in January, and look for one with more margin. Our catering equipment and supplies in Dandenong page lists the refrigeration ranges we keep in stock locally.
Used commercial fridge inspection checklist
PAPERWORK AND OUTSIDE
- Data plate readable: model, serial, rating, refrigerant
- Power lead and plug undamaged
- Cabinet free of rust and major dents
- Castors or legs level and secure
DOORS AND INSIDE
- Paper test passed on every seal
- Doors close firmly on their own
- No fogging between glass panes
- Liners, shelves and lights intact, no odour
MACHINERY
- Condenser coil clean, no oily residue
- Compressor runs steadily, no knocking
- Fans spin freely and quietly
- Drain clear, no water pooling
PERFORMANCE AND SUPPORT
- Reaches 5°C or below on your thermometer
- Recovers quickly after doors open
- Warranty terms in writing
- Parts available for the model
Tip: Take this list and a probe thermometer to every inspection.
Questions to Ask the Seller
The physical inspection tells you how the fridge is today. The seller can tell you how it got there. Whoever you are buying from, ask:
- How old is the fridge, and where was it used before?
- Has it been serviced, regassed or had major parts replaced?
- Why is it being sold?
- Has it been running in the last few days, and can I see it running now?
- What warranty applies, and does it cover parts and labour?
A private seller may not know every answer, and that is fine, but vague answers on age and history should make you more careful with the temperature test. A dealer should be able to answer all five. Knowing how to inspect a used commercial fridge is half the job; knowing what to ask is the other half.
Where you inspect matters
A showroom lets you see the fridge running in a controlled space, often beside its new equivalent. A private sale or auction may mean inspecting a unit that has been switched off, packed against a wall or sitting in a hot storage shed. If you cannot see it run, you cannot judge it properly, so either insist on a running test or price the risk into your offer.
Different Fridges, Different Checks
The eight checks apply to every fridge, but each type of commercial fridge has its own weak points worth a closer look.
Upright storage fridges
Uprights are the simplest and most reliable used buy. Focus on the seals, the condenser and the temperature test. Check the shelf supports carefully, because missing clips are fiddly to replace on some older models. Our upright storage fridge range shows typical new and refurbished options for comparison.
Under-bench and drawer fridges
Under-bench units live in the hottest part of the kitchen, right beside the cooking line, so compressors work hard. Check ventilation openings are clear, drawer runners slide smoothly and drawer seals close evenly. Compare against new models in our under-bench refrigeration range to judge the price.
Glass door and display fridges
Display fridges add glass, lighting and sometimes anti-condensation heaters to the list. Look for fogging between panes, check every light works and watch for condensation running down the outside of the glass, which can point to a heater fault. These units work hardest in summer, so the temperature test is especially important.
Prep fridges and freezers
On sandwich and pizza prep fridges, check the top wells hold temperature as well as the cabinet below, and that the lid seals. On freezers, look for heavy frost build-up and confirm the unit keeps food frozen hard. A freezer that struggles in the showroom will struggle far more in a hot kitchen.
Self-contained or remote
Most fridges in cafes and restaurants are self-contained, with the compressor built in. Some larger display fridges run off a remote condensing unit installed elsewhere. Remote units need a refrigeration mechanic to install and connect, which adds cost and complexity. For most buyers, a self-contained unit is the simpler used purchase.
Refurbished Fridges We Have Already Checked
If you would rather skip the inspection, buy a fridge that has already been through it. These refurbished, ex demo and as new units from our current range have been checked and tested before sale. Stock moves quickly, so treat them as examples and see the full list on our refurbished equipment page. For help sizing the right fridge first, read our guide on how to size a commercial fridge.
Trusted Brands and Quality You Can Count On
New and refurbished stock changes through the year. Ask the team what is on the floor today.
MRCE in Numbers
Melbourne Refrigeration & Catering Equipment, supplying Australia’s hospitality industry since 1984
Flexible, tailored kitchen equipment funding
Why rent when you can own? MRCE offers a flexible funding solution for commercial kitchen equipment, tailored to suit the hospitality industry.
- ✓No hidden costs
- ✓No balloon payment at the end
- ✓Claim the GST upfront at the start
- ✓Own the equipment from day one
- ✓Fast and streamlined approval
- ✓Funding options to suit your application
Check the running costs too
A fridge that passes every check can still be expensive to run if it is old or inefficient. Where the model has an Energy Rating label or registration, compare its energy use with a current model of the same size. On a fridge that runs around the clock, a more efficient unit can recover part of a higher purchase price over the years. For a broader look at choosing between fridge types, see our guide on choosing the right commercial refrigeration.
From Inception to Completion, End-to-End Project Management
From inception to design, throughout installation to completion, let our expert staff oversee your project. No matter how large or small, we work closely with architects and consultants on your commercial kitchen and bar requirements. We arrange qualified service technicians for equipment problems whenever they crop up, a kitchen that’s down is a kitchen losing money. At MRCE we aim to keep our customers coming back as their business grows.
Buying a used fridge from us is the start of a service relationship, not the end of a sale. If a seal wears or a fan starts to whine a year later, our technicians already know the unit and can fix it quickly. When you are ready to add more refrigeration, browse the full equipment catalogue for new and refurbished options.
How to Inspect a Used Commercial Fridge, or Let Us Do It for You
Now you know how to inspect a used commercial fridge, you can walk into any private sale, auction or showroom with confidence. Or you can save the time and buy one that has already been checked. Our team runs these tests on every refurbished fridge, explains what was found and puts the warranty in writing. Browse our commercial refrigeration range, or contact our team to ask about a specific unit before you visit.
Questions, concerns, or need a hand?
Don’t hesitate to reach out. MRCE’s dedicated team is ready to provide the support you need: a quick technical question, a quote on a specific unit, a finance enquiry, or a full kitchen fitout. We’ll point you to the right answer, even if that’s not buying from us today.
Get in touch with our teamVisit, call, or email us
Showroom
15 Station Street
Dandenong, Victoria 3175
Australia-wide shipping available
Get in touch
Phone: (03) 9794 8627
Fax: (03) 9794 7258
Email: sales@melbournerefrigeration.com.au
Trading hours
Monday to Friday
Sales / Service: 9:00am to 5:00pm
Admin: 8:30am to 3:30pm
Saturday: By appointment only
Please call during the week to arrange. Closed on public holidays.
What we cover
Sales, finance, free consultation, installation, fitout management, after-sales service and 24/7 technical support.


0 Comments